Automatic bottle blowing machine safety operation specification necessary knowledge
(1) Before starting up each shift, lubricating oil must be added to each moving part once. (Manipulator, manipulator guide rail, mold opening and closing guide rail)
(2) The swing arm can be added once (3-4) days. The large chain and small chain of the heating machine can be used once a month. Frequently check whether the main engine reducer and the heating engine reducer are short of oil. The host bearing can be added once every 3 months.
(3) Before production, check whether the moving parts are firm, whether the screws are loose and fall off, especially where the impact is strong, whether the belt drive part is abnormal.
(4) Check whether the high-pressure gas source, low-pressure gas source, power supply and water source are normal.
(5) Check whether the emergency stop switch, safety door switch and protection device detection switch are normal.
(6) Check whether the heating head enters the embryo and the embryo dropping part works normally. If the blastoff is not in place, the nut of the blastoff device can be adjusted.
(7) Check whether the lamp tube is damaged or broken. to be replaced in a timely manner.
(8) Check whether the pneumatic components are leaking and whether the action is sensitive.
(9) Check whether the triplet leaks abnormally, whether it is blocked, and whether the water cup is too full.
(10) automatic blow molding machine solenoid valve in case of abnormal, to timely cleaning every blow bottle 3.5 million cleaning once 〉.